The SWEEPSAVER is the first-of-its-kind tool that eliminates the struggle of cutting a shower door water diverter sweep quickly and evenly.

The raceway is the channel at the bottom of the tool.

Cutting vents are the slits found on the front of the SWEEPSAVER. The bottom vent is 1/8”, each vent after that is an additional 1/16”.

A unibody component made up of dual durometer material.

Yes, a SWEEPSAVER uses a #9 or #12. We prefer a #12. It is a thicker more stable blade for a more controlled cut.

If there is too much down pressure (drag friction) the tool will not glide. Resistance occurs when the SWEEPSAVER is not flush with the sweep. The SWEEPSAVER was built to act as a straight line plane. Make sure the tool is flush with the sweep. 

Most common cause: Something is stuck in the raceway. 

Other possible causes: The razor blade is dull or the SWEEPSAVER is not parallel to the sweep.

We recommend a new razor blade for every 1-2 jobs which is equivalent to two cuts per blade corner.

Use a thin awl or pick and slide it in the raceway.

After every use - always check raceway for obstruction.

Check out this quick video to learn other ways to get the job done! 

Click here.

If purchased from STILLMORELLC.com and you are not completely satisfied: Email HELLO@STILLMORELLC.com, include your first, last name and order number. 

If purchased from a retail store: Contact retail store.

If purchased from a retail store but you are outside of their return policy AND you have registered the product through STILLMORE LLC’s warranty program: Email HELLO@STILLMORELLC.com, include your first, last name, the email address you registered the product and the cause of the claim.

If purchased from a retail store, but you are outside of their return policy, visit STILLMORELLC.com to purchase a new one.

Email HELLO@STILLMORELLC.com, include Wholesale Inquiry to subject line.

For additional questions please email HELLO@STILLMORELLC.com.